Cable Clamps Slap Snap

Cable clamp Strut Ready Slap Snap

Benefits include:

Cost: A common mistake throughout industry is making decisions by comparing costs of each component of a system individually rather than reviewing the overall system cost including performance, labor, quality care, etc. However, direct cost comparison cannot be overlooked. Average Slap Snap cost is double higher than common clamp. However, the Strut Ready™ Slap Snap® is applied in seconds whereas it takes 5-6 minutes to install a channel clamp. If you were to install 48 channel clamps it would take about 2 hours, an equal number of Strut Ready™ Slap Snap® could be installed in less than 15 minutes. Consequently you save on the remuneration of labor. Similar savings occur when a cable adjustment or change is required. Ease of application: The Slap Snap® can be applied with one hand. Productivity increases 3 to 4 times over traditional cable ties or Velcro Tie Wraps. Both of these devices require two hands to apply and special tools. Users report they have experienced productivity increases of 25% and higher with use of the Slap Snap®. Reusable: When you have to add or remove a cable from the bundle you will complete the operation in a few seconds. Cable tie wraps must be cut and replaced with another one. Replacing one plenum cable tie wrap equates to the difference in cost of the Slap Snap®. Practically you use 5-6 cable tie wraps instead of one, because they are not reusable. Only this one fact whittles down the difference in cost. There is also a risk of damage the cable when cutting a tie wrap, that increases the final cost of cable ties. Velcro cable tie is reusable but it’s quality deteriorates with each using. Performance: TheSlap Snap® is designed so that cable bundles cannot be over tightened minimizing pressure on the cable thus signal transmission is not interrupted. Tie wraps tend to crimp the cables and are often overtightened exerting excessive pressure thus signal does not flow smoothly; this also leads to faster deterioration of the cable. As the amount and speed of data passing through cables increases the impact of crimping on data transmission also increases. Safety: The flared outer edges and interlocking teeth design of the Slap Snap® will reduce installer injury. Tie wraps when cut have very sharp edges leaving the installer exposed to serious injury which in turn results in lost labor time and higher workers compensation costs. The Plenum rating validates that it reduces the potential of injury caused by heat, smoke and fumes in the event of fire.

Slap Snap is UL certified and Plenum rated.

Ordering information:

SS0405	Cable clamp, max. diameter 12 mm
SS0410	Cable clamp, max. diameter 25 mm
SS0415	Cable clamp, max. diameter 38 mm
SS0420	Cable clamp, max. diameter 50 mm
SS0042S	Cable clamp, with fastening, max. diameter 50 mm
SS0044S	Cable clamp, with fastening, max. diameter 100 mm